The pipework taking shape in the tender connecting the four vacuum tanks together.
Photo: Clive Briscoe

A view of the completed reverser arm.
Photo: Laurence Armstrong

A general arrangement view of the completed reverser arm.
Photo: Laurence Armstrong

The mechanical lubricator bolted onto the right hand running plate.
Photo: Laurence Armstrong

Underneath the right hand side mechanical lubricator showing the new supporting brackets.
Photo: Laurence Armstrong

A view along the top of the frames showing the route the vacuum pipe run takes.
Photo: Laurence Armstrong

The drain cock operating arm on the lay-shaft that then operates the drain cocks on both cylinders.
Photo: Laurence Armstrong

One of the drain cock operating rods on the running plate after receiving some attention. This is now considerably straighter than it was!
Photo: Laurence Armstrong

This is one of the sander operating rods and shows the typical bent condition the sander and drain cock rods were in.
Photo: Laurence Armstrong

The card templates to check the hole alignment for the drain cock valve linking plate.
Photo: Laurence Armstrong

One of the card templates in place to check fit.
Photo: Laurence Armstrong

A drain cock valve linking plate after drilling.
Photo: Laurence Armstrong